LinuxRacr's Haltech E6X Log..
- Thread starter LinuxRacr
- Start date
HiBoost TS
Member
jrodhotrod said:
Never play with either of the HEX screws in the idle control motor or the stop screw (blue). If you want to play, do it with the By pass screw.(red)
jrodhotrod
Contributor
- :
- 2003 Mazda Protege5 (Mine) 2002 Nissan Sentra GXE (Wife's)
Yup, good to know. Thanks again.glyph said:
Well, I'm sitting at McDonalds here in Hillsburro, TX dealing with another cold start issue. I am on my way to visit my Grandmother, and have been here for 3 hours. It has been raining on and off. My daugher is having a blast though in the playland. The only difference of today is that it is raining, and a little warmer than usual. I pulled the plugs and they were a little wet, so I crank-dried the cylinders, and put the plugs back in. When I tried to start it up again, it caught like it was fixing to start, but then it didn't, and kept turning over on subsequent tries. Just finished charging up my laptop, and finding this open wifi network, so it's time to go try again. Wish me luck.
For those who think I am complaining, just know that I am documenting my experiences. This is a log thread.
For those who think I am complaining, just know that I am documenting my experiences. This is a log thread.
Right after I posted the post above, I went out to the car, pulled the fuses from my E6X, and cranked it (per Steve Kan who I had just talked to). I put the fuses back in, and started it right up. I went to Waco to visit family. My car started everytime it needed to after that. On the highway the E6X is a dream. It pulls so hard! I must say that Corky designed a great intercooler. Even though most of it is behind the bumper, I have been running 10 PSI without ping (and retarded timing). Getting in lane-cahnge battles with people who didn't want to let me over, the look on thier face when they couldn't out pace me...priceless...
- :
- 2001 Mazda MP3
(rofl)RyanJayG said:
(laugh)
