HKS CBE help

[DK4214]

today i installed a HKS Catback and a turboxs race pipe and there is a really bad rattle at the end of the exhaust where it goes over the axle. could that be the hanger rubbing or it not supporting the exhaust enough over the axle? also the exhaust has a huge angle and is rubbing my rear bumper a little . Has anyone had this noise or problem with there CBE? i will try to post pictures and vids soon.
thanks again.

 

[boosted1]

I had the same problem with my '08 MS3. It has a big tip and the system comes in at an angle. You could try to have an exhaust shop realign the system. I believe the exhaust hangers should be replaced with a urethane set,also. CorkSport sells a very good set.

 

[DK4214]

Thanks i will look into them!

 

[DK4214]

its actually not the hanger its the pipe. Its rubbing against the metal where the rubber hanger is connected to the frame of the car above the left side of the axle.

 

[boosted1]

The tip of mine was hitting the opening in the fascia. It would rattle at startup and other times at random.

 

[DK4214]

cut it off its rattle free now!