FS: MS3/6 COBB AP, Griffin TMIC, and MS6 CAI

Status
Not open for further replies.

boostin4

Member
:
RX8
Ok back story. I bought a white MS6 from a board member in september and a month later it was totalled. I was hit by a red light runner and the insurance company thought it would be to much to fix. So after dealing with the insurance and thinking about what next car I was going to get; I went ahead and bought RX8. So this lends me to sell the items I was able to take. All these items are in great shape, car was hit in right rear.

COBB AP for Mazdaspeed 3 or 6. recently unmarried, check photo
$$SOLD$$

Griffin Top Mount
this was bought by orginial owner but can atest to its cooling ability. after a 30 min spirited run the IC was still cool to the touch. This also fits under the factory shroud, so no need to worry about the dealer or lookers. Inlet pipe will only fit the 6; 3s will need to remove theirs and transfer it.
$$SOLD$$

CP-E MS6 CAI
Was bought from fellow board member. Used for 500 miles. Still in box, received on friday morning, wrecked on friday night. Just looking to break even.
$190 shipped
CIMG0439.jpg

CIMG0438.jpg
 
Last edited:
keep me in mind if you get desperate on the IC.. id make an offer right now but, im runnin an ETS and would need to get some numbers on that unit.. its a custom piece or are these sold somewhere?? and the cold pipe is included??
 
it says it was made or sold?? by road race engineering in so cal.. they do lots of evos out here and are supposed to be pretty good.. i guess this piece was made before the ets unit was out.. and when the autoexe was the only one out for $1400..(boom04)
 
I remember reading either on this forum or another that the griffin was a custom job where the endtanks on the stock tmic were cut off and welded onto the griffin core, I thought this was a one-off deal where the original owner was trying to gauge interest for a cheaper more efficient alternative to the higher priced tmic that were on the market at the time
 
hey worbit!! look at this intake.. theres also an AEM kit with carb sticker too!! on another thread..
 
Status
Not open for further replies.
Back