Current Engine bay pics everyone
- Thread starter nautical2086
- Start date
funkalicious21
Member
- :
- Mazda Protege 5 Turbo
dubby...doing a klz turbo'd? =P just a guess
- :
- 2003 Mazdaspeed Protege
speedracer
Member
- :
- '03.5 MSP
lookin good Rob!
- :
- 2003 Mazdaspeed Protege
Thanks! Now it just needs some venting from a RC hood!
EDM6-zoom zoom
Member
- :
- 06 mazda 6
freekwonder
Contributor
- :
- Datsun 510/Nissan Frontier
uummm...not being a dick or anything, but your camber plates are installed incorrectly. (nailbyt) right now, the way they're installed is only for caster...forward and back, with no camber.
it should be an easy fix though.
jack up the car, remove the strut bar and push down and rotate the camber plate to its proper position. car will probably drive a whole lot better too.
oh, but nice looking engine bay otherwise!
here are some pics of my bc's.
it should be an easy fix though.
jack up the car, remove the strut bar and push down and rotate the camber plate to its proper position. car will probably drive a whole lot better too.
oh, but nice looking engine bay otherwise!
here are some pics of my bc's.
red95_240sx
Member
yep...maybe he wants caster tho. ksports have camb slots at the knuckle mount.
Spiced MSP
Member
- :
- 2016 Peterbilt 579
Here is a pic of my engine bay on my MSP. I recently took the Forge BOV off due to backfiring between shifts, surprisingly no stalling issues though(did not relocate the MAF sensor). But anyway, Im running the stock bypass valve until I can get a better bypass valve or BOV recirculated.
Attachments
red95_240sx
Member
really?
- :
- 2003 Mazdaspeed Protege
uummm...not being a dick or anything, but your camber plates are installed incorrectly. (nailbyt) right now, the way they're installed is only for caster...forward and back, with no camber.
it should be an easy fix though.
jack up the car, remove the strut bar and push down and rotate the camber plate to its proper position. car will probably drive a whole lot better too.
oh, but nice looking engine bay otherwise!
here are some pics of my bc's.
You know I was actually trying to find pics of them installed on something else the other day cause I figured they weren't on right. I appretiate you letting me know, I'm not much for fiddling around and adjusting the suspension too much but I'll definetly be switching them around now. I'm assuming after dropping them down and turning them I'm gonna have to get another alignment? Correct me if I'm wrong about this.
red95_240sx
Member
unless its dead on in the middle from the factory.
sexy! i love some clean BP!(humpleg)
