Re-did my sub/amp box install

[FunkyBuddha]

Well..I went from 2 subs to this. Smaller 10" sealed box. Pounds tighter.

 

[DaViper]

Looks nice, but I would consider making a fiberglass one in the future so you keep your trunk space (it looks a little tight now when you wanna throw stuff in there, and you have to worry about damaging your sub with stuff being against it). Looks nice though!

-DaViper

 

[Giallou P5]

I would make it 2 seperate pieces, jsut incase you need to remove it or put it in back seat. so u can slide it.

the 10 sounds better than 2 12's

 

[FunkyBuddha]

It is 2 pieces. 4 screws remove that fake panel, and then i disconnect the ground and power and out comes the whole thing.

 

[MisterT]

Nicely done! Looks clean

 

[chuyler1]

Very clean. Good job. Fiberglass isn't for everyone. I'd much rather see your install than a sub box floating around in the trunk. Some people just don't have the time for fiberglass. You have gone above and beyond the average install by creating a nice trim panel and hiding all the wires. That is farther than most people get.

 

[FunkyBuddha]

Thanks for the positive comments guys! Actually w/ my old 2x10 box and the amp mounted on the back, the trunk space was pretty tight. This way, I gained at least 2 inches in trunk depth. A bit more room.