Recent content by caprisun

speed...And by the way! The dealer still hasnt gotten back to me about that ball joint. Wonder if its a hard to find part or something...

Update! Took her in and the wheel is just fine. But the dealer found a nail in the same tire $15 fixed. And he also found the rubber boot over the ball joint is torn a bit but isn't threatening to the joint itself. Rather, it will slowly let dirt and grime in over time and should be...

bova, thats VERY interesting...was that post recent? Has anyone else had an oil change done at a dealer recently with 5w-40 as recommended?

speedster3, Could that just be crap from the new piping part burning off?

Photos to come soon. So would you say curbchecking is "hit or miss" as far as replacement goes? (no pun intended)

Somethings fishy. Was the TSB for the antenna?

Ok, so...I know I haven't posted lately but Its been hell with some really long workweeks lately. Anywho... Yesterday, I messed up and curbchecked the hell out of my front passenger wheel. Its a helluva scrape and doesn't look pretty. The wheels are chrome and I don't really mind if the one...

2006/ 14500

Thank you for serving. 2-The thing to remember is that the production numbers of this car are VERY low. (10,000) Therefore, things that may be typical problems are best addressed through community fourms (like here) to share and discuss to better pinpoint what to do about it. 3-Just what OJ...

amillie, Steve is obviously flippin burgers while ur at kinkos straight up flippin copies!

amilliems6, Yea I think thats the route to go for sure. The MS CAI is WAY overpriced, and the risk of hydrolock isnt appealing. ms3action, So if you DONT get the inlet pipe as well when you get the sri is it easy to install later? Or do you need to remove the sri again to slap the inlet on...

Ok so... I decided to order the CPE mount and do it myself with my buddy and some Coors within the next week or so as I have some time off then. After inspecting the short shifter instructions MANY times over today I decided I wasnt quite comfortable using a power drill on the shifter midway...

Is it really that much cheaper? If that's the case, then it really would be a better option...is it simple to put the stock gear back on if need be for work?

Ok, So... I got the mod bug bad...so... I called my service guy to ask about how the dealer would react if i were to install mounts and a short shifter, to which he said it will not void any warranty (unless something such as shift linkage were affected and damaged)... On another note, he...

One more thing! What about Downpipe and Catback installations? I think the DP is more difficult, correct? Thanks!