2017 Mazda CX-5 GT. I've recently replaced my brakes I started to get the CEL with error code P2610. During the replacement, I put the e-brakes in maintenance mode to be able to fit the new pads and rotors. I made sure I followed the procedure posted here and ended the maintenance mode correctly.
Troubleshooting steps I've taken so far:
- checked the battery and it's good (>14V)
- replaced one flickering dome LED bulb (aftermarket purchased on Amazon) but left the other functioning ones in place
- checked the 15A fuse (there is a TSB for that) and it's good
I reset the error code but it came back the next day. The car has no accessories installed other than a remote starter iDatastart (installed 3 years ago) which works fine with the exception that when I use it, it disables the Auto-Hold brake function (it was like that from the beginning).
I'm running out of ideas. Does anyone know what else I can check? Thanks in advance
Troubleshooting steps I've taken so far:
- checked the battery and it's good (>14V)
- replaced one flickering dome LED bulb (aftermarket purchased on Amazon) but left the other functioning ones in place
- checked the 15A fuse (there is a TSB for that) and it's good
I reset the error code but it came back the next day. The car has no accessories installed other than a remote starter iDatastart (installed 3 years ago) which works fine with the exception that when I use it, it disables the Auto-Hold brake function (it was like that from the beginning).
I'm running out of ideas. Does anyone know what else I can check? Thanks in advance
Last edited: