Innovate LC-1 Wideband & A/F gauge w/pillar

Status
Not open for further replies.

mightyray

Member
:
03 MSP Protege Black Mica
I had the unit and gauge installed in my MSP for a couple months and decided I didn't need it. It comes with all software and instructions for install (more detailed on the innovate website). I'm also including the serial adapter so you can interact with it on your laptop (this was like $25 at best buy). The unit was just inspected and tested by Innovate who also updated the firmware. I'm including all extra wires needed to install this in a MSP along with a custom punch out with the test button and display light mounted (see below). I'm also including a copper heatsink I fabricated which fits on the stock J-pipe. The pillar was made by someone on this site and it fit nicely in my MSP. The gauge is clean and has the plastic still on it. This is a pretty sweet unit and should give you an edge in tuning your car. Message me if you have questions. Asking $200 plus shipping.

ebay001.jpg


ebay003.jpg



Gauge and Pillar

ebay002.jpg


Custom Punch Out

ebay007.jpg


Copper Heatsink

ebay005.jpg


Serial Cable

001.jpg
 
i can get a brand new one off ebay Shipped at the price you offering

Yeah just the unit, but without the gauge, pillar, punch out, serial cable, copper heatsink, and extra wire specifically for a protege. Also the unit was only in my car for a couple of months and it has the updated firmware which I bet the ebay ones won't have.

LC-1 Unit = $200+ new
Gauge/pillar = $100 new
Heatsink = $20
Serial Cable = $25
Punch out = Careful drilling
 
Bump. Could a mod move this to the mazdaspeed protege section since this unit is fitted for a msp?
 
Status
Not open for further replies.

New Threads and Articles

Back