What have you done to your P5 today?
- Thread starter Tg5
- Start date
i am aware that it is AWD... what i was saying is that we have FWD so we can't do that, and i'm jealous
- :
- 2006 Infiniti M
gtx and gtr are both awd. the gtr is a gtx on awesome juice. better front end, better engine, better turbo, better engine everything. so hot.
- :
- '04 RX8
I got high from my exhaust gases, rich POS lol
- :
- 2016 GT ST 47A
Nice....can't wait to see those pics.
Today I swapped out my AEM intake for an AEM intake. I had the mtx on my autotragic and picked up a used atx one from Rosshole. In the process I relocated my coolant resorvoir and finally swapped the stock DS lo-beam bulb out for the new Osram Silverstar.
Last edited:
- :
- 2016 GT ST 47A
Haha...yup..edited my post so that it will make a little sense.
- :
- '13 CWP MS3 & '16 Mazda6 GT
no, he wants to give it to me 
- :
- 2016 GT ST 47A
I will keep you in mind. Someone else has dibs but if that should fall through, it is yours. Looking for $65 shipped (what I paid) plus you get 2 oil filters as I bought a dryflow filter over the summer.
I will keep you updated!!
- :
- 2016 GT ST 47A
no, he wants to give it to me
Drive up!
**edit** On that note, time to go home! Woot!!!
Drive up!
**edit** On that note, time to go home! Woot!!!
If you'da said something sooner, a friend of mine just flew back in town from PA yesterday. But, yeah, I'm first in line if your other buyer falls through!
Oh, by the way, is it black or polished?
And, is it a ram or a full intake?
Tylor
- :
- 2016 GT ST 47A
It is red and I am sure it is the SRI...please someone let me know if it is the CAI. Here's a pic, but keep in mind that it is installed differently on my car due to the fact that I have an auto and the intake is for a manual.
Attachments
ah, now I get it lol. That wasn't exactly clear in that first post
no problem, my bad...
also today had snow tires installed and went back to the stock rims, Goodyear Eagle Ultra Grip GW3 H, rated #1 overall by a long shot by consumer reports.
installed springs...go ahead and flame b/c i installed msp springs w/ stock struts and have a saggy butt. but i'm a poor college kid and it only cost me 50 bux. o yea and ignore the dirt on the side, it rained the other day and haven't had a chance to wash it
on the upside, i took it for a spin down a winding road and i notice a difference, so i'll deal w/ the .5 in lower in the back
on the upside, i took it for a spin down a winding road and i notice a difference, so i'll deal w/ the .5 in lower in the back
Last edited:
- :
- -- 03 P5 / 23 CX-5 --
Look at the line of the bottom of your car in that pic and the line of the top of the curb. They are parallel. The saggy butt is an optical illusion produced by the body lines of the car in most instances except the extreme. Measure from ground to top center of your wheel arches & I bet they are equal. Your lowering is proper in this case IMO. Nice bargain. Looks fine. Enjoy.installed springs...go ahead and flame b/c i installed msp springs w/ stock struts and have a saggy butt. but i'm a poor college kid and it only cost me 50 bux. o yea and ignore the dirt on the side, it rained the other day and haven't had a chance to wash it
on the upside, i took it for a spin down a winding road and i notice a difference, so i'll deal w/ the .5 in lower in the back
Last edited:
yea i know. i actually measured it... by the # of fingers tall
thanks man. appreciate it. if i had the money i would have gotten tokicos and s techs...maybe next car when i am out of schooli think it's mostly b/c the front wheel well starts higher up on the body. ggrr
