WTB: exhaust screws

[2k3 PrO RiDa]

WTB: exhaust nut

I stripped one of the nuts that connect the axleback to the catback piping and I need another one.

 

[TheJohnny]

good luck, they are welded on from the factory on the back end of the bolt. Best bet would be to take a dremel and cut the weld off the old one then knock it out with a hammer then but a new nut and bolt in there. Just my opinion but it's probably your only option.

 

[2k3 PrO RiDa]

No I dont need the part that's welded on so I guess im talking about the bolts you use to tighten down the exhaust?? I stripped one pretty bad.

 

[TheJohnny]

who's your Daddy now........ I know I know..... your welcome.

 

[nate0123]

No I dont need the part that's welded on so I guess im talking about the bolts you use to tighten down the exhaust?? I stripped one pretty bad.

it's called a nut

 

[nate0123]

not sure what the interior threading is, but the outside is 14mm

your best bet would be to take the other one off, take it to lowe's or home depot and find one that matches the threading

 

[TheJohnny]

if the nut is stripped what are the chances that the bolt is also? Pretty good if you ask me...

 

[nate0123]

well, it's either "stripped" or the hex part is rounded off

 

[2k3 PrO RiDa]

yea only the hex part is rounded off.

 

[TheJohnny]

I SEE you updated the 1st post as well.......... Home Depot Or Lowes is your friend. If you buy it from Mazda it'll be like $3.00 per nut. I just had to order some that I wasn't happy about ordering....but I did anyway.