Wiring Color help needed

[Secondtyme]

Hey all, I have LED turn signals to put in and the load resistors to ensure they work properly. However I have no idea which of the two wires leading to the turn signal socket is the positive feed. There is a striped and a solid color wire, which one is it? Also, is there a cluster ground for the entire assembly or should I run an independent ground to the load resistor? Thanks much in advance for any help...

 

[sac02]

Multimeter?

 

[Secondtyme]

I forgot to "borrow" the good one from work and my trusty home model is busted.

 

[Vasy]

Hmm....
if you watch 16 minutes to about 16:30 you can see the wiring on a 2012, hope not much change on 2006, at least the sequence should be same if not the colours.

 

[Secondtyme]

Well I got them installed and as soon as I started the work I realized that I'm an idiot. There are only two wires, so you really can't screw it up. The badly photocopied instructions that came with them made it appear as though you needed three wires. Anywho, my rear turn signals are now blinding my fellow motorists LOL

 

[vesko_m]

Pics needed.
What type of LEDs - Tritons or other?

 

[Secondtyme]

Got them from the same place I get all my LEDs, SuperbrightLEDs.com. I went with the 3watt amber turns and 3watt dual intensity red stop/brake w/ three second flash. I will try to get some night shots up, but they really aren't anything special, just really, really bright.