Ok I have done a few searchs and haven't come up with what I am looking for. What I need to do is remove both my side marker light and my bumper lense. I have a 2002.5 so I have the marker light up on the fender in front of the driver and pass doors and then also the lense on the bumper. I am tinting all of them and need to know how to detach them because after inspection I don't see any screws. Any help would be appreciated.
Side marker Removal???
- Thread starter FuNwaGoN
- Start date
From what I understand ... The removal of the bumper lenses involves removing the mudflaps from the front wheel wells, and then unscrewing the lense from the inside of the bumper.
As for the sidemarkers alongside the doors, i believe the driver's manual shows you how to change the bulbs, which of course includes removing the lense itself.
Good luck!
PS. I'm replacing my bumper lenses on Wednesday (tomorrow). I'll put up a how-to, if people would like, but it doesn't seem too difficult.
As for the sidemarkers alongside the doors, i believe the driver's manual shows you how to change the bulbs, which of course includes removing the lense itself.
Good luck!PS. I'm replacing my bumper lenses on Wednesday (tomorrow). I'll put up a how-to, if people would like, but it doesn't seem too difficult.
the turn signal sidemarker just pops off like everyone says. you can put masking tape and on the body to prevent scratches and sue a screwdriver. these are so easy to jack.
the front bumper ones are connected in good. The easiest way to pop them off would be to take the whole front bumper off but this is a MAJOR waste of time. Just do what everyone else says.....reach in, disconnect the wire, and pop it out.
the front bumper ones are connected in good. The easiest way to pop them off would be to take the whole front bumper off but this is a MAJOR waste of time. Just do what everyone else says.....reach in, disconnect the wire, and pop it out.
