hello all, if you familiar i got 2 msp's now, bought one for motor
got swap almost completed, but a few hoses etc i dont want to get messed up.
water outlet pipe, lt side of block (if you are sitting in car) front part goes to rad, rear goes?
there are 2 metal tabs on the wiring harness, they are located on the same strand as the knock sensor (at least i think it is a knock sensor) that is on the left front of the vavle cover, i do not remeber where they go, they are about 2 inches long and taper at the end and appear they jut get bolted on as grounds but i am unsure.
what is the best location to get the vacumm for boost controller, boost gague, wastegate, bov etc,
those are about the only things holding me up from getting this all bolted together, sorry i do not have pics =(
got swap almost completed, but a few hoses etc i dont want to get messed up.
water outlet pipe, lt side of block (if you are sitting in car) front part goes to rad, rear goes?
there are 2 metal tabs on the wiring harness, they are located on the same strand as the knock sensor (at least i think it is a knock sensor) that is on the left front of the vavle cover, i do not remeber where they go, they are about 2 inches long and taper at the end and appear they jut get bolted on as grounds but i am unsure.
what is the best location to get the vacumm for boost controller, boost gague, wastegate, bov etc,
those are about the only things holding me up from getting this all bolted together, sorry i do not have pics =(
