Kenetixs' Dyno Sheet

[Kenetix]

It handles it, for now ....... I dont know about the long run.

 

[2K3 MSP]

Exactly what would happen when the tranny can't handle the power anymore?? I know what happens when you throw a rod(the link of the 2002 RSX-S for example), but never seen a tranny F'd up. Would it be a simple as replacing the tranny, or could it screw up other things along the way? Of course assuming this was in a 300 HP MSP, not my stock 150HP MSP

 

[AFaceInTheCrowd]

you get EXTREME jerking and even a dead stop. might jack up the torque converter. if it's bad enuf, gear pieces will fly throught the bell housing and damage your engine.

 

[LinuxRacr]

I assume you are refering to an automatic with a torque converter?

 

[AFaceInTheCrowd]

yeah i am with the torque converter. i know that standards don't have one.

i assumed he was talking of general tranny failure and i decided to throw that one in as well.

 

[MP3skaterNC]

the tranny should be fine as long as you don't beat the s*** out of it. let it drop into gear, dont shove it, and just be kind to your transmission. I personally think alot of the tranny failures on this site are from people constantly dogging on the transmission, anything is going to fail if you beat it constantly.

 

[mygreenmazda]

Hey Kenetix so this run was made at 18psi and by the way have you already upgraded to a bigger turbo, thanks and by the way sorry for the bs flag on your last thread I just needed proof but this did it, good job and sorry again.

 

[Fakhelek]

I've never seen a dyno sheet with MPH on the X axis. I'm no expert, but shouldn't that be RPM? What's up?

 

[mygreenmazda]

That is the same thing I was just thinking about.