Clutch Master Cylinder Part Number

[treflip180]

Does anyone have the part number for the clutch master cylinder for 2002 Protege5? Thanks in advance.

 

[03.5MSP]

This is what I found on the Mazda catalog. Part # GE4T-41-990C

 

[Hank3]

This is the one I got from Advance Auto a month ago. Haven't installed it yet so I can't guarantee that it works 100%:

http://shop.advanceautoparts.com/we...-master-cylinder-perfection-clutch_19340058-p

Cost $14.28 shipped. There's a always a discount code going around on slickdeals or go to retailmenot.com

 

[tweety2300]

I can tell you auto zones sucks. Also make sure to take some oil and put it in where the clutch pedal pushes in, not a while lot or you will make a mess but just a little bit if you don't Itl squeak

 

[treflip180]

GE4T-41-990C is correct. There must be two different ones cause the dealership needed my vin number as there are two different part numbers for the m.c. on my year model. Anddd, with something as important as the master cylinder, I think i'll go oem. They also offer a repair kit, anyone have any experience with those?

 

[treflip180]

Also can anyone post a pic of the bolt you have to remove under the dash to remove the clutch master cylinder? The service manual isn't very helpful.

 

[tweety2300]

Don't have a picture but you have to pull the clutch switch out to see/ get to it, pretty sure they're 10mm nuts. Watch that plate it will cut you. I had to stop the first time cause I had so much blood going down my arm

Also both times I've done it I dropped the nut and it went under the carpet so be carefull with that

There is no space, easiest way for me was pulling the seat out setting a pillow down and laying in my back with a small flash light in my mouth to see. But I'm 6'2 so I don't exactly fit in small spaces well