Where to Tee into for Boost only line

[Jasnall]

where specifically should I tee into for the boost only line to run to my synapse bov?

 

[pidass15]

Pull off the intercooler (assuming your running stock tmic). Look back where the turbo is and find the hose that runs to the wastegate on the turbo. Use the pic on Synapse's website:
http://synapseengineering.com/smf/index.php?topic=39.new;topicseen#new

it's the second to last picture.

 

[Jasnall]

like this?

 

[SgtP]

yes sir!

 

[Jasnall]

i hope the tee is an ok size, it seemed a little small but its the only one that would really fit in the hose. could it cause restriction problems?
Whats that hose to the waste gate do?

 

[zoom-zoomhatch]

I'm thinking it's the hose that tells it when to open.

 

[SgtP]

as long as it was a pretty snug fit you will be fine.

 

[Jasnall]

thanks SgtP. What are your thoughts on:

I went for a spin last night and the driving changed a little.
It felt like the boost was a little slow to react...if i were to sit around 4k rpms and punch it, it seemed to hesitate for a second then blast off.
When I first drove it with only one port plugged in (A) the response was awesome. Better than stock, picked up boost really fast. So i dunno whats going on.

 

[SgtP]

it shouldnt hesitate. try without the T in the boost line and see if anything changes. i am installing mine tomorrow and im using the biggest brass T's i can find that will fit.

 

[Jasnall]

hmmmmmmmmmmm brass t's nice, i think ill do that too. Hardware store? or auto place?

 

[SgtP]

Napa