What have you done to your MSP today?

lol.. i know what you mean.. i tend to not drive mine very much at all.. in 2 years.. ive only put 10K miles on it.. and 1800 of that was driving from utah
 
ive put on 40k in 2 years.... like 10k in 6 months... but I drove to an from Minot ND several times....
 
eh I can see it if he has a long commute.... I average bout 50 miles a week now tho...
 
omg omg omg <3


The Turboxs Type H BOV rocks with this kit <3 sounds like god!!!!!!!!!!!!!!!!!

I finially have it installed!
 

Attachments

  • TurbolifeFMIC installed.webp
    TurbolifeFMIC installed.webp
    49.6 KB · Views: 158
eh I can see it if he has a long commute.... I average bout 50 miles a week now tho...

I was driving all over the state for about 4 months. 1 day at each of our 130 stores spread all over the eastern half of the state.. (I only did half of them), my actual commute to the office is about 7 miles. lol
 
true, i just have a pretty good selection of what to drive.. my MSP, my Iroc Z or my Caddy CTS.. so thats why i dont put many miles on it

eh the MSP is my Daily... I cant really drive the 55 every day, it wont run off of pump gas to well... and the miata is missing one minor part, the motor lol
 
omg omg omg <3


The Turboxs Type H BOV rocks with this kit <3 sounds like god!!!!!!!!!!!!!!!!!

I finially have it installed!

for those of you with moneys lol... I'm makein my own.... but it will look good, I dont like cutting corners on a car... had a bad experience once... hole through piston and rod through block...
 
for those of you with moneys lol... I'm makein my own.... but it will look good, I dont like cutting corners on a car... had a bad experience once... hole through piston and rod through block...

Lol, the turbolife kit isnt that much :P HiBoost kit is expencive haha.

But i had to cut courners a little bit when installing, both pipes have a brushed alumium look with them cause didnt have time to powdercoat them ;(
 
for those of you with moneys lol... I'm makein my own.... but it will look good, I dont like cutting corners on a car... had a bad experience once... hole through piston and rod through block...

your own fmic? I'm doing the same... got the core mounted, and the turbolife cold pipe in the basement... just gotta figure out a hot pipe solution and couplers... get the BOV flange n weld it on... should be all set!
 
I have a wideband in my bedroom, haha, but not forsale :P
Also have another boost gauge and WOT box :)


Anddddddd JUST GOT MY MOTORMOUNTS :) cant wait to have them on, mine are bad :(
 
Lol, the turbolife kit isnt that much :P HiBoost kit is expencive haha.

But i had to cut courners a little bit when installing, both pipes have a brushed alumium look with them cause didnt have time to powdercoat them ;(

I may be able to get you so powder coat... but all we use at work are Colman Green, the Blue that are on the Burnzomatic propane tourches, this bright asyas yellow that burns easily, and a gloss black...
 
I have a wideband in my bedroom, haha, but not forsale :P
Also have another boost gauge and WOT box :)


Anddddddd JUST GOT MY MOTORMOUNTS :) cant wait to have them on, mine are bad :(

well, I dont need a boost gauge... but I'll take the motor mounts and let you keep the wideband lol
 
Back