What have you done to your MS3 today?

[daonly1around]

damn, three scangauges?

 

[supergoose]

Removed rear wiper and put new black lug nuts on the rims.

 

[DaleNixon]

damn, three scangauges?

I like to monitor 6 parameters at once, so it's perfect

 

[kilik2]

you should become a reactor operator then...

 

[DaleNixon]

How's the pay?

 

[Sport6]

Seafoamed the car today. Changed the oil after that as well.

http://www.youtube.com/watch?v=Aob1RTv5ggA

 

[kilik2]

How's the pay?

depends on whether you are civilian, military, licensed, not licensed. but bteween 60k and 120k.

 

[Bravnik]

Seafoamed the car today. Changed the oil after that as well.

http://www.youtube.com/watch?v=Aob1RTv5ggA

I have a can of this in my garage but have yet to use it. I'm a little scared to be honest. How did the car drive after? Is there a noticeable change?

 

[Sport6]

I have a can of this in my garage but have yet to use it. I'm a little scared to be honest. How did the car drive after? Is there a noticeable change?

Well too be honest, after I drove it around a few miles with the seafoam in it and then changed the oil, I havent driven it with the fresh oil... I have been terribly lazy today. I will go for a ride in a few though to see how it performs.


Edit: Went for a drive, drives smooth but still had a tiny bit of smoke when i came back and parked it. Probably wont run this oil change to 5000 miles because theres probably some seafoam still in there..

 

[mr_mazda329]

Edit: Went for a drive, drives smooth but still had a tiny bit of smoke when i came back and parked it. Probably wont run this oil change to 5000 miles because theres probably some seafoam still in there..

Did you add it to the fuel system or did you feed it in with the vacuum line?

 

[Sport6]

Did you add it to the fuel system or did you feed it in with the vacuum line?

Vacuum line.

The smoke might be residual from the exhaust system but we'll see.

 

[09Speeder]

Installed my injen cai today - took me a few hours and ended up sawing off the spash guard because i did not want to take off the front bumper and could not unbolt it though the wheel well.

Seemed to add a little push throughout the rev range and sounds like a damn hissing snake when it winds up. (drive2) Nice....

 

[mr_mazda329]

Installed my injen cai today - took me a few hours and ended up sawing off the spash guard because i did not want to take off the front bumper and could not unbolt it though the wheel well.

Seemed to add a little push throughout the rev range and sounds like a damn hissing snake when it winds up. (drive2) Nice....

Cool...pics?

 

[dkswim]

well changed my oil added my hid fogs. remover the metel ring from inside

 

[mr_mazda329]

well changed my oil added my hid fogs. remover the metel ring from inside

Any pics?

 

[Saskatchewan17]

Full Detail:

 

[pjo113]

She looks fantastic, good job!! Gotta love the true red MS3s, I know I love mine.

 

[dkswim]

what did you use the stainles cleaner on?

 

[ericrapp]

i bet it was and is to remove the soot from the taipipe again and again and again...... car looks very well.. Red! and shiny too.

 

[Saskatchewan17]

what did you use the stainles cleaner on?

Exhaust tip... it works really well. Keeps it pretty clean and if it gets sooty it wipes off without any effort.