Studs for MSP

[Brannon9827]

Can anyone point me in the right direction for some main studs.
I need head studs and main studs. I found studs for the head from ARP that part# is 218-4703.
But now I am in search for a set of main studs.

 

[Brannon9827]

I didn't think about this earlier but would the stock bolts be fine for what I am doing?
List of what im doing.
Hardpipes
BOV
Air intake
Pope exhaust manifold
Wiseco Pistons .40mm
Forged Rods
Air intake Manifold
Head is being resurfaced and bored w/valve job

 

[hornsfan10609]

Stock bolts will work fine. There is no 'need' for ARP hardware, some people just like to spend money

 

[Brannon9827]

That's good to know.

 

[Keno1542]

I thought the main studs were torque to yield and could only be used once...might as well spend a couple extra dollars to upgrade if you have to buy new bolts anyway, and at least the arp studs would be reusable.

 

[hornsfan10609]

Head bolts can be reused if they are within spec but most people don't. You can get head bolts for $40 vs studs for over 100