My Simple daily CX5

[Andre_Pratama]

Hey nice to have a friend from same country here. are you from medan Felix? based on your police number.
LOL. good looking car btw

 

[SayNoToPistons]

Very nicely done and clean mods.

 

[Chris_Top_Her]

Would you mind making a side view showing the lip?

 

[felixd]

Hey nice to have a friend from same country here. are you from medan Felix? based on your police number.
LOL. good looking car btw

Thank you Andre

 

[felixd]

Would you mind making a side view showing the lip?

Yeap Will do take some photo . just waiting to paint n install and clean the car. the weather isnt too promising this week lately.

 

[felixd]

Very nicely done and clean mods.

thank you SayNoToPistons

 

[felixd]

Finally i got something done this week . After researching the correct ratio on how to mix the paints, i decided to give my self a shot first time with a spray gun. Fingers cross

Primer coat & wet sand (2 day process)




Fresh base coat paint (cosmo grey)

 

[Chris_Top_Her]

looks good

 

[undergrad.]

Did you remove your side mirrors when you applied the vinyl to them?

 

[felixd]

Did you remove your side mirrors when you applied the vinyl to them?

hmm i didnt remove the side mirrors at all , i vinyl the black plastic part only.

 

[felixd]

Lastly clear coat done . 25/3/14



Installed 25/4/13 Car is not clean at the moment will take another outside view when cleaned.







Yeap will do another full car shot soon for us all this week. Just FYI if you guys want to get this tail gate lip. when installing make sure you center it properly because once you stick on the 3m it will be too damn hard to take off and very careful because the material is fibreglass ...as i forgot to double check on the centering position thus installation was off by a tad.

The error:

 

[CX-5tormtrooper]

Great paint job on the lip! Do you have any other pictures that aren't so close up?

 

[SayNoToPistons]

I WANT THAT SPOILER LIP! Looks great!

 

[Chris_Top_Her]

I've been eyeing that for a while, I saw someone had it on a german forum a while ago, but they only had one bad picture that didn't show the car profile.

 

[felixd]

Rear View

 

[felixd]

Haven't been updating on my daily CX5 , did a couple minor changes :

I have removed the tacky chrome for the rear reflector and install a custom stainless steel axleback to replicate Racing Beat system , as it is very pricey & difficult to source one from overseas sent out to my country.
<iframe width="560" height="315" src="https://www.youtube.com/embed/eZzTkiBdA2I" frameborder="0" allowfullscreen></iframe>

Also installed front Genuine Mazda LED DRL bar kit from Mazda Australia.



Stay tune for more Zoom Zoom.

 

[chavy]

Hi, What did you use as the red insert? it looks good!

 

[felixd]

Hi, What did you use as the red insert? it looks good!

Just a metallic red vinyl wrap.

 

[felixd]

Minor update. After seeing a thread about paddle shift kit . At last i have mine installed. Here are some pics .

The paddle shift kit :



Before Zoom - Zoom:




After Zoom - Zoom:

 

[Conrad 16.5]

Felixd,

Your CX-5 looks great! Well done.