Liquid Urethane Filled Motor Mounts

[91Protege]

So I finally got around to filling my new stock mounts. It was 129 for all 4 mounts, and 27.99+ shipping for the liquid urethane.

Tape 1 side of the motor mount, seal with some rubber cement. Set all mounts in a box filled with sand or cat litter to catch whatever drips off or through the duct tape.

Make the fix, then fill em up.

These 2 ended up not being full when I went to ck on em, had to order another kit to refill

These 2 came out great.

 

[mazdaspeedp]

looks good

 

[Alejo_NIN]

compared to real aftermarket mounts, how long would these last and what durometer would it match?

 

[jdwk]

Where did you get all four new mounts for $129? Rock auto?

 

[BOOSTR]

Nice work. But I didn't think they looked like OEM mounts. Don't think you can even get one of those for $129, let alone all of the 3 engine and 1 trans mounts.

 

[jeremy irons]

I have done this before. I hope that you cut out some of the rubber "separating" the two sides before pouring. or you may find that the urethane pops out after a while

 

[91Protege]

I got off ebay, they are some knock off ones. The fill is rated at 80a durometer. Cut what out? I didnt cut anything.

 

[zogy]

When you get them installed, please report back on the vibration level with respect to the stock mounts. It will be another data point ..... I have some new mounts in my future and an still on the fence about which way to go.... THX

 

[91Protege]

I will be putting in shortly, I just got my liquid kit and finished what I started the other week.

 

[sde780]

I used polyurethane window adhesive from Lowes/Home Depot. Cost less than $10 and my mounts are rock-solid.

 

[91Protege]

Lol, i didnt even think of that.

 

[91Protege]

Put the mounts in today, took about 1hr 30 for all 4 mounts. The back 1 wasnt as much of a PIA as everyone said it was. The mounts seem solid for now, a bit more vibration then I had, it wasnt to smooth since I got it. The old mounts were destroyed.

The rear mount

 

[jdwk]

It's kind of like a movie. If you go in expecting it to be awesome, you will be disappointed, but if you go in expecting a disaster, it won't be that bad.

 

[E4w]

How are your mounts? I did the 3m window weld mount fill a couple years ago on my 04 mazda 6s(v6), but no luck...