Intercooler fitment

[ARunto]

My friend has a intercooler he is trying to sell me. Here are the dimensions: 30.5in X 6.5in X 2.25in. Piping size is 2.25 on one side and 2.5 on the other. Anyone have dimensions of FMIC that they are using on MSP or MP3.


I attached a pic of it below:

 

[BlackMSP]

that will fit but you always have to hack a little something off your bumper...

 

[03SpeedLSD]

Looks very nice! You will have to notch the bumper to make it fit. The only prob I see is, you might have problems running the pipes past the fogs or under the chassis. Once mine goes on in 2 weeks, I will show you what I am talking about. And just to be nosey, how much is he selling it for??? Later,

 

[BlackMSP]

ya how much0 deniero?

 

[t3ase]

Finished pics are mandatory for both of you.

 

[perfworks]

that should fit BUETIFULLY
damn spelling!!!
any way right under the bumper support it should and you should be fine. last time i checked you had close to 7.5 inches in hieght to play with because of the fact the intercooler pipe conections can go low enough with the one you showed

 

[All Boost]

Have you put that intercooler in yet? I have one that looks like that too, but with plastic ends and 25x7.5x1.75.
thanks

 

[azian6er]

hey a runto, that is the exact intercooler i am using. It fills the bumper so much more nicely then the spool or ion fmic that i have seen because it is a little longer and has a better end tank gonfiguration. I have trouble with my piping around the drivers side fog light but it isnt too bad.

That is one nice fmic i must say.

--B