Intake Manifold Install Question/Help!

[RallyeRedSi]

What is this plug supposed to be plugged into, or do i have to cover it?

 

[RallyeRedSi]

Bump

 

[SwirlFX]

Oh its the vics vacuum line.

 

[RallyeRedSi]

so what should i do???

 

[SwirlFX]

IIRC it connects to one of the VCIS actuators on the left side.

 

[SwirlFX]

http://www.nsnmotorsports.com/docs/images/thermal install/bolt3.JPG

If you using the original tubing still you should be able to tell which line goes to which actuator. One is longer than the other. I hope that helps, I've only does this swap once on a friends car.

 

[blueprotegelx]

did you figure it out? i plan on doing this install next so i'm trying to familiarize myself with intake.

 

[greasemonkey524]

With the 626 mani. you just leave them as they are. I put little caps over mine bacause you don't need them anymore. Just don't unplug the electrical connector or you will most likely throw a CEL. Do that with both the Green and White plugged ones. One is for the VTCS and one is for the VICS. Here's what I did...

 

[RallyeRedSi]

i have the white one hooked up to a vacuum, should that not be?

 

[terbow]

since you have no butterflies i wouldnt think it matters. they just actuate the butterflies. since theres none i cant see how it would matter unless they open up at a certain time then u might get a leak since its not a loop anymore. if u dont need em i would just plug both ends on both.

 

[RallyeRedSi]

cool, thanks everybody

 

[mspHtown]

cool, thanks everybody

how are you liking the manifold?

 

[RallyeRedSi]

best mod for the money