I toggled display off with Mazda Connect, now what?

[hotelzulu]

Punching myself in the face, I tapped on the "Display Toggle" script using MZD-CONNECT-1 to access terminal mode with v74. And now my display is black and I can't get it back. I've googled around quite a bit and can't figure out any way out of this. Does anyone have a solution? (or is it a trip to the dealer?)

Thanks in advance,

Paul

 

[hotelzulu]

Actually as it turns out I spoke too soon. Sure the display came back on when I re-installed the firmware. But afterwards, when the car was locked up and after 5 minutes, the screen is off. So I'm going to just buy a used KN3L-66-9C0 CMU and install it! If that works it will only be a $90 mistake. (back to punching myself in the head).

Paul

 

[hotelzulu]

Good news, I simply purchased a used CMU on eBay for $86 and swapped my old unit out. It worked fine right of the bat. The only thing I had to do was delete all the previously saved favorites, BT connections, etc. Grateful it was only an $86 mistake. After I swapped the unit, I updated it to 74.00.324 and then ran MZ-CONNECT-1 tweaks again, this time NOT TAPPING DISPLAY TOGGLE!

Paul

 

[MzdCX_5]

You didn't have to re-install the firmware, all you need is to use the flashlight to navigate to Reset to factory default and the problem would've been solved.

 

[hotelzulu]

You didn't have to re-install the firmware, all you need is to use the flashlight to navigate to Reset to factory default and the problem would've been solved.

Reset to factory default using which menu? The tweak menu only works with the touch (as far as I could tell), and that was disabled when DISPLAY TOGGLE was hit. I did not try a mouse though.