I am replacing the drive side rear bearing hub and cannot get the axle out of the spline in bearing!
I’ve tried hammering, I’ve used a puller, pry bar, etc. is it possible the spline teeth are seized? Or did I miss something?
I ordered a new cv axle expecting the current one is no good but I still need suggestions on removing the old one.
Any help would be appreciated!
Thanks
I’ve tried hammering, I’ve used a puller, pry bar, etc. is it possible the spline teeth are seized? Or did I miss something?
I ordered a new cv axle expecting the current one is no good but I still need suggestions on removing the old one.
Any help would be appreciated!
Thanks
