I have got inventory of a ton of different strut bars and was thinking of developing one for the P5. I was going to take the ends off one that fit closely and re-drill the holes as needed. Then measure and find the bar that will fit between the two.
This would require drilling a 1x2" or close to it hole in each side of the plastic in the back, but would probalby make a nice addition to your suspension set up.
Cost on these would probably be around 70 to 80 bucks but maybe cheaper if it doesnt take me long to find the correct bar.
Also, ill probalby make one just to make it, but before i started selling them there would be a few things to discuss. For instance, i am doing this on my own and not as part of my company. Im using parts from a closeout buy that are non returnable, but nice quality, so i cannot warranty or return these.
If anyone is interested let me know. Id like to have some interest before i spend the time making them.
This would require drilling a 1x2" or close to it hole in each side of the plastic in the back, but would probalby make a nice addition to your suspension set up.
Cost on these would probably be around 70 to 80 bucks but maybe cheaper if it doesnt take me long to find the correct bar.
Also, ill probalby make one just to make it, but before i started selling them there would be a few things to discuss. For instance, i am doing this on my own and not as part of my company. Im using parts from a closeout buy that are non returnable, but nice quality, so i cannot warranty or return these.
If anyone is interested let me know. Id like to have some interest before i spend the time making them.