forge wga questions

[mazdanick]

does any one know what type of spring i need to push 9 ibs of boost on a forge wga without useing a boost controler or if i need one to boost that much because i am only boosting 5 know

 

[patty AT forge]

We rate the green 5-10 psi. You'll need a good bit of pre-load to get to 9.

 

[mazdanick]

do i need spacers for the spring for pre load to get 9 or i was wondering what is that set screw on the side of the wga and how do you adjust the wga to up the boost and lower

 

[patty AT forge]

The set-screw is actually a block off for converting the actuator to a dual port set-up.

No spacers needed, all of the adjustment is done with the turnbuckle.

 

[mazdanick]

thanks im just still learning about this stuff that will help thanks