Not sure if this is the right place to post as i couldn’t post in the diy section. Anyway,
Difficulty : Easy.
Things you need.
1. Soldering iron
2. Audio grade MKP 6.8uf capacitors (matched pair)
3. Tesa tape (to prevent rattling)
4. Insulation tubing (for the capacitor’s lead)
Remove the A pillar and tweeter, desolder the original electrolytic capacitor (take note not to overheat it. You could melt the plastic.)
Replace the capacitor with audio grade mkp capacitor. You get a more detailed high frequency and smoother sound.
Any mkp capacitor works. As for how much improvement depend on your choice of capacitor.
This mod is very low cost with a good result.
Careful of the size of capacitor you choose, if it’s too big you won’t be able to put the A pillar back.
The capacitor i used has 20mm diameter (theres still extra room for bigger capacitor)
Enjoy the music.
Difficulty : Easy.
Things you need.
1. Soldering iron
2. Audio grade MKP 6.8uf capacitors (matched pair)
3. Tesa tape (to prevent rattling)
4. Insulation tubing (for the capacitor’s lead)
Remove the A pillar and tweeter, desolder the original electrolytic capacitor (take note not to overheat it. You could melt the plastic.)
Replace the capacitor with audio grade mkp capacitor. You get a more detailed high frequency and smoother sound.
Any mkp capacitor works. As for how much improvement depend on your choice of capacitor.
This mod is very low cost with a good result.
Careful of the size of capacitor you choose, if it’s too big you won’t be able to put the A pillar back.
The capacitor i used has 20mm diameter (theres still extra room for bigger capacitor)
Enjoy the music.