datalog

[koston33]

So I just took my car out for a spin using ffs and lc. First off I set my lc at 33000rpm and my ffs to 4600rpm. My vehical speed limiter was set to 10. I have since chanced my lc to 2900 and my ffs to 5000 and kept the 10. anyways here is my datalog with my first parameters in place. Oh and I spun like a bat out of hell in first and second. Anyways just wanted a more expert opinion as to the load I'm putting on my engine. Do my numbers look safe?

 

[koston33]

just some input would be good

 

[8.5MS3]

need more info. mods?

your running a bit lean, 11.6-11.8 would be the ideal afr at wot

that knock at 5.6k is something i would be concerned about. its probably knocking all the way to redline. after about 5.5k the sensor cant hear knock anymore, so it may not be 0

your wastegate is basically slammed shut to keep 20psi. unless your stage 2 thats a bit high

how are your fuel trims?

 

[Sport6]

It's easier to read a datalog and diagnose problems if its a single gear (4th) rather than all the off throttle (gear changes). Its hard to see when you are in gear after 2nd with all the FFS stuff holding rpms and throttle open.

 

[koston33]

Mods are Mscai mm and stage 1+mscai 93. I will do just a fourth gear pull and upload it thanks