Bigger turbo, here is my shopping list....anything missing?

[EngulfinFlames]

Alright. so i'm currently in Afghanistan. I have the Autobahns of Germany as my playground when i return. Contemplating taking the leap and getting a GT3076r along with what I believe to be proper supporting mods. Here is the list so far. (see SIG for current mods)

GT3076r
Arias Piston and Pauter Rod Combo
HKS Twin Power DLI Ignition Amplifier
HKS Type 0 Turbo Timer
KMD Armoloy Coated High Pressure Fuel Pump Kit
ARP Head Stud Kit
Cometic Head Gasket
PG Turbo Inlet
COBB AP

and of course , all this followed by a proper tune. Anything missing or anything that should be replaced? Thanks.

 

[GoSpeed3]

might want to think about porting the head and int manifold if you actually want to make power on this engine,

 

[Speedkid]

Are you going iwg or ewg?

 

[mattj3636]

your gonna want ewg with a custom manifold to fit it.

 

[Captain KRM P5]

http://www.protegegarage.com/product_info.php?products_id=1655

we offer it with EWG and they are sitting here, in stock, zero wait

 

[Ricktalife]

http://www.protegegarage.com/product_info.php?products_id=1655

we offer it with EWG and they are sitting here, in stock, zero wait

holy ducksauce batman! is that the gain at stock boost?

 

[Captain KRM P5]

holy ducksauce batman! is that the gain at stock boost?

yes it is

 

[EngulfinFlames]

Actually I was thinking this one

http://www.protegegarage.com/product_info.php?cPath=160_251&products_id=1553

Ken, you offering the Wastegates too or whats in the pic is what i get?
I already have the 1st Gen PG manifold before the revisions and its tearing up my TXS FMIC coupler.

 

[crossbow]

Don't forget some super sticky tires to handle all that power .

 

[EngulfinFlames]

And those too, they are already figured into my budget (band2)

 

[opt_ms3]

contact DCR. do everything on this page. http://www.dcrsrt.com/index.php?act=viewCat&catId=27

get a proper turbo with a proper flange, not that ATP s***. do it right. port and polish the intake manifold. buy this, seriously: http://www.maperformance.com/maperf...anifold-mazdaspeed3-ms3rev3-p2.html?&cat=1337

might as well get a higher reading MAP sensor. I think AEM makes one that can be used? not positive on that one.

but seriously, getting that turbo is pointless without headwork and a PnP intake manifold.

 

[EngulfinFlames]

Actually the shop i'm taking it to can do all my PnP work

 

[mzspd3soffl]

You dont need low compression pistions, the stock ones are fine i heard "i kno someone with the setup. a lil different tho." Jus rods would be ok. You dont need a turbo timer, better off using that money on labor. haah lol and HDF makes a better fuel pump. and u dnt need to port the head. that rediclous expensive. Good look with ur build. I hope they take there sweet time. wouldnt want nothing to go wrong. You should take it easy on the tranny n buy N2mb so u can keep the gt 30 spinning between shifts. An some nice tires n ur set ; )