you are a god my friend, a god
88 front bumper swap(s)(mazda noob!!!)
- Thread starter 323b6t
- Start date
you are a god my friend, a god
So I went to the local Mazda dealership and ordered the bolt a crush washers.
I've been under my car all day putting in my new shifter bushings
and I was looking for the connection for the knock sensor and I couldn't locate it at all
idk if I'm looking In the wrong place or what but I haven't got a clue where it is.
Will it run w/o it?
If so is it safe to drive about 2 miles at my local shop an have them install it?
I've been under my car all day putting in my new shifter bushings
and I was looking for the connection for the knock sensor and I couldn't locate it at all
idk if I'm looking In the wrong place or what but I haven't got a clue where it is.
Will it run w/o it?
If so is it safe to drive about 2 miles at my local shop an have them install it?
Boost gauge: T into the Over Boost Solenoid vacuum line.
MBC: Ile have to double check how mines plumbed in. Im too tired to remember.
ive already got the mbc figured out thanks to clubprotege :]
but now that ive been on there from time to time.... i realized that ive been asking yall to spoon feed me
lol sorry
but now that the car is pretty much ready to crank and all i recently found out that my bagging and tagging skills are at an all time low and ive lost my thermostat house bolt and the nut.
ive called every mazda dealership w/in 75 miles and every single one of them say that there should be 2 bolts ( which is whats comes on the B6 sohc)
any idea on how i could get the bolt and the nut
- :
- All Mazdas!
The size for the bolts should be a M8 x 1.25 thread pitch. I don't remember the length though. Some models have a stud in 1 spot and a bolt in the other.
-Derrick
They are M8's. Im pretty sure those matched the demensions that I gave you.
update.!!!!
the car fired up from the first key turn and was smoking a heavy blue smoke.
but i like it warm up and idle for about 10 more minutes and the smoke stopped and she back to normal :]
the only issue i have at the moment is that my valves clicking pretty loud.
will this quite down??
its about is loud as a "cam killer" b-series honda
the car fired up from the first key turn and was smoking a heavy blue smoke.
but i like it warm up and idle for about 10 more minutes and the smoke stopped and she back to normal :]
the only issue i have at the moment is that my valves clicking pretty loud.
will this quite down??
its about is loud as a "cam killer" b-series honda
- :
- All Mazdas!
If they are new HLA's, then they will need a little time to pump up with oil. My new HLA's in my head when I rebuilt my motor took over 2 hours to quiet down. Everything is fine now with no issues. Sometimes its quick, other times it takes a long while. Eitherway, Take it easy till they quiet down.
they are quiter now that it been cranked daily but it hasnt left the drive way due to a bad heater core that is currently being fixed...
but im excited to trim out the imark bumper ASAP.
and krylon it.
but idk if i should go w/ the atmosphere BOV or the BOUSH recirculating.
i just hate the way the recirculating looks, cause im a HUGE fan of wire tucks. Even tho a bf is damn near impossible to wire tuck i still would like to keep it neat and tidy looking
