NEED4SPEED
Member
Im trying to get a feel for how fast this MSP can go. So post your times if ya have em. Also, specify what your mods are.
0 - 60 times (boosted/non-boosted)
- Thread starter NEED4SPEED
- Start date
NEED4SPEED
Member
6.5 stock? Every magazine i've read says 6.9 - 7.1. Doesnt it say 7.1 on the website?
Anyway, im not askin for what magazines say or what brochures say, i wanna know who here has actually clocked thier time and what mods they got.
Anyway, im not askin for what magazines say or what brochures say, i wanna know who here has actually clocked thier time and what mods they got.
Well
According to my Vericom my 0-60 times are in the high 5 to low 6 second range with a "HUGE" amount of wheel spin.
It is very hard to get it to hook up. I don't like to abuse my car so I didn't do it over and over just about 6 runs and after the wheel hop episode I said **** it. That wheel hop is ******* sad. I would love to find a way to greatly reduce this; that does not include new mounts.
According to my Vericom my 0-60 times are in the high 5 to low 6 second range with a "HUGE" amount of wheel spin.
It is very hard to get it to hook up. I don't like to abuse my car so I didn't do it over and over just about 6 runs and after the wheel hop episode I said **** it. That wheel hop is ******* sad. I would love to find a way to greatly reduce this; that does not include new mounts.
http://www.mazdamp3.com/vbb225/showthread.php?s=&threadid=24527
at 6psi , the 0-60mph will near to 7 second.
at 6psi , the 0-60mph will near to 7 second.
jonnydoe48
Member
look at yashooa's post. his 10-12 psi is high 5's - low 6's.
tritonheat1
Banned
- :
- 06 MS6, 98 A4 1.8T Rebuilt
Don't believe magazines they are way off in 0-60 and 1/4mile times for some vehicles like the MSP and SpecV. The best i've seen for stock SpecV 1/4mile times was 15.6 and we all know the SpecV (Stock) pulls a 15.2-15.3sec 1/4mile time with a good normal driver. I think same for the MSP, C&D tested the MSP in september and they got a 6.9sec 0-60 and 15.4sec 1/4mile time. I have seen Number's also from Motortrend 0-60..6.5sec 1/4mile..14.9sec, and if you average the two "you can just say the MSP pulls low to 15's flat. For an example lawerence took his car to the track and got a 14.92@92.85mph (Stock). I think you just have to know how to drive to pull a good 1/4mile time. 
Don't feel bad I did 3 run's and on my 1st run lots of wheelspin I went all the way up to rev limit with wheelspin ooops. did 7.3sec
on my 2nd run did better but still to much wheelspin did 7.1sec last run did a lot better play with the clutch a littel still some wheelspin but not to much on 1st but on 2nd there was some spinning but I was moving result 6.8 sec....
on my 2nd run did better but still to much wheelspin did 7.1sec last run did a lot better play with the clutch a littel still some wheelspin but not to much on 1st but on 2nd there was some spinning but I was moving result 6.8 sec....
richelesro
Member
- :
- 2003.5 BYM MSP
6.96 just the other night with minor wheelspin before I got the flash. I'm going to do it again after the flash, again after downpipe install, and then again after MBC install.
