Recent content by mysleeper6

  1. M

    FMIC issues!

    Yeah, I'd say you are confusing the hell out of the ECU; you're venting metered air so I'm guessing you'd be running way too rich. As they sit, these cars were meant to have a bpv, not a bov. And before everyone else says it, you need some means of monitoring what the ECU is seeing. The...
  2. M

    Cobb AP Discussion Thread

    Autotech.
  3. M

    What have you done to your MS6 today?

    Yeah, I used to run just a testpipe, and I was smoking pretty bad at idle; I've found that I smoke with the dp too. I'll start by raising the idle a bit, then try some of the other remedies.
  4. M

    What have you done to your MS6 today?

    Installed an ebay downpipe. Took my time, hardest part was getting the old dp out. Gotta get my compressor back from a friend; made a leak checker and I want to make sure I'm good to go before loading up a stage 2 map.
  5. M

    Please dont get mad at me

    Get a bnoon bolt (restricts oil flow to turbo) Bnoon is the manufacturer's screenname on msf.
  6. M

    Brake pulsation on brand new 2?

    This is perhaps the most persistent myth in automotive history. Rotors do not warp. However, improper bedding can lead to the friction material (brake pad) being transferred unevenly to the rotor. You can either resurface them, or rebed them properly (do about 6 or 8 hard stops from 60 to 20...
  7. M

    What have you done to your MS6 today?

    Installed Autotech Fuel Pump internals.
  8. M

    What have you done to your MS6 today?

    Ordered HPFP internals. Getting tuned and showed a little dip at peak load, so until they get here I'm staying out of boost. :(
  9. M

    What have you done to your Mazda6 today?

    Installed ITV-22 plugs and did the coil spring mod.
  10. M

    Dashhawk

    Still for sale.
  11. M

    Dashhawk

    NFL Countdown bump!
  12. M

    Dashhawk

    Bump it up!
  13. M

    Dashhawk

    SOLD! I have a used Dashhawk for sale Included is the Dashhawk, OBDII cable, and the original box. The Dashhawk has an aluminum "L" bracket attached to it, with velcro on the bottom. The cable has been repaired; it was this way when I bought it. It has always functioned flawlessly. I think...
  14. M

    LED turn signal question

    Hey guys, if you'll note the dates, this thread is over three years old. There may very well be solutions now that will work for your specific application. I have LED flashers on the rear corners of my Speed6 that were plug and play, no resistor or other modification needed.
  15. M

    WTB: Dashhawk

    How much you willing to part with? I came across your thread searching to see what they're worth before I sell mine. I never use it anymore; I'll have to plug it in and make sure it still works, lol.
Back