Recent content by Ligouri Rd.

  1. L

    How and y did u get in to mazdas or tuners.

    I was a Mazda Rev-it-up waiting for my turn on the course and opened up the back of a 6-5 door. Holy crap this thing had a lot space. I had driven one on course at last year's event. Even with a 4 cyl it pulled and handled light years better than the pickup I had at the time. I had owned the...
  2. L

    Mechanical Engineer looking for job!!!

    ↑ I guess I have just had some bad dealings with head hunters. I got set up on an interview with a company, and was told the only time available was first thing in the morning. I got there before the interviewer had even shown up. It makes him look bad for not being prepared and me look bad but...
  3. L

    Mechanical Engineer looking for job!!!

    Finding a "good" job is all about networking. If you had a high performance vehicles concentration then you should have had contact with the folks in SAE. A person that knows you and can vouch for your ability goes a long way, there are a lot of positions out there that are not listed. Don't...
  4. L

    Good Performance shops for Mazdas

    PMed 07mz3. I don't mind spending a little more if I can go get it right now. $5 shipping for a $7 part does make much sense right now. Thanx
  5. L

    Good Performance shops for Mazdas

    Along the same lines as the origonal poster, does anyone have any recommendations for performance parts, specifically the madison area? I am looking for AN fitings. I need one fitting and would rather not pay for shipping on that one item. Thanx in advance.
  6. L

    my S14 240sx build......

    Forgive the reply two months later (haven't been on the board in a while) , but anyhow: I don't know how you could start a ka with any part of the timing cover off. The lower cover has has both the oil pump and the water pump mounted to it and the upper has the distrubutor attached. So no, the...
  7. L

    my S14 240sx build......

    Well after I installed mine I would start to run out of gas before I got below a quarter tank. Just lettin ya know.
  8. L

    my S14 240sx build......

    Very nice build, I will be eventually putting an GT-series in mine when my manifold cracks again(an AMS manifold is waiting in the wings). Did you get a prelude sock for the walbro pump? If not I would recommend it, the sock that typlically comes with the kit will not get all the way down into...
  9. L

    Anyone sing?

    Just to my car and to my GF...she must have some hearling loss or something, cause she doesn't notice my tone deafness.
  10. L

    leggo my eggo!

    ... Oh wait, never mind I buy Country Delight Waffles. Whew!
  11. L

    How do you eat sushi?

    Some years ago some of us from work took a japanese client out for lunch at Todai. All of us americans are picking up our sushi with chop sticks, some failing more than others. The Japanese client looks at us strangely, shakes his head, and says "Sushi finger food".
  12. L

    Madison Meet?

    A: When, tomorrow, time? 2: Where, Quaker Steak? ...mabye. Depends on how much packing I get done 2nite...flying to Germany on sat.
  13. L

    wrecked/salvage cars

    That looks to me like it just go pulled from the bottom of the bayou. Or at least that is what pier sections look like after we pulled them out of the lake in Wisconsin when we flooded last year.
  14. L

    Smelly gas contributers?

    Last new years eve this steak restaurant had Apple glazed pork chops on special. They were quite good but the aftereffects were appalling. Doing shots before heading out for the nights festivities and trying to keep from falling on the floor laughing from the comments of "damn what died in...
  15. L

    Lego model V8 engine

    Better are the engines that actually run: http://www.lpepower.com/content/pushrod-v8-engine
Back