Recent content by geetee

I also have this problem. I'm led to believe that RING do a fog light which fits in this space exactly, for about 20% less than Mazda want for one light!!! Or, you can do what I'm doing and fit fog light delete trims from Street unit. :D

Not a chance. I have 18x8 rims with -47 offset, and 215 wide tyres and still had to roll the arches. I'm lowered on Eibach springs. The rims where originally -50mm offset, but I fitted a 3mm spacer. 235 rubber and a 40 offset won't just rub your fender, it will more than likely wreck them if...

Are you having a laugh??? (evil) Theres no way these cas are zinc coated. There was areas of my wheelwells I could scrape down to the bare metal with my fingernail!!! The paint is very thin on the wheel arch lip, minimal effort required to remove it. You'l lfind the best chip protection BEHIND...

Well I did my driver side today, the Mazda underseal man should be shot in the head and then sacked!!! (notcool) We don't get bad snow like some of you guys, but we do get salt/grit mixture spread on all our roads. I can't really go to Mazda with mine, as I've kinda modified my arches to take...

The K&N panel and drainpipe mod...... :D Takes air from the undertray, just ahead of the gearbox. Driving through rivers is not recommended.... I dunno if it actually works powerwise, but it sounds a bit better. Not as loud as an induction kit, just slightly louder than standard.

How many miles have you done? Could be a blocked oil strainer in the oilpan, or a blocked filter.

I would say those parts are your original parts, and have been dipped and stripped, possibly in rust remover, then re-fitted without any protection. Or at least the calipers. Theres no way those are new.

The reciever is behind the side boot or trunk trim, on the driver side. Thats your driver side, not mine. :D

You can save the rear links by taking both struts off at the same time, along with the sway bar. Thereby negating the need to remove the links from the struts.

There is decent ones on Ebay.... I have a 4" slash cut, universal fit, and a custom SS over axle bend. Cost me about $90 from Ebay UK, including P+P. And it sounds like this. http://smg.photobucket.com/albums/v487/nellyeff/?action=view&current=Eastmainscutandcomp.flv Must say though, that...

Pretty much the same as this one mate. http://www.geocities.com/crx_auto/eagle_eyes.htm

I have absolutely no idea, Guiness is most definately an Irish tipple. You can ask me anything about whisky though. HIC!!! (evil)

Thanks mate, I'm kinda waiting to finish a few minor mods, then I'll update the pix. ;) Heres a couple... I'm waiting to buy some ducting to make a cold air feed to my standard airbox.

Made them myself :D

Meguiars do a superb clay bar kit, but theres probably a cheaper alternative.