-
-
Nnegusm replied to the thread 2008 Mazda5: How to remove glove box and parasitic current drain?From the Factory service Manual. You pretty much are required to have it to work on a car these days.
-
Nnegusm reacted to huesmann's post in the thread 2008 Mazda5: How to remove glove box and parasitic current drain? with
Like.
Not sure if this helps. -
Nnegusm replied to the thread Front right radar sensor dislodged and brokenProbably take it to the dealer. These systems all require the dealer to reprogram and calibrate after replacing the broken part. I...
-
NOk. For anyone else It Was The Bloody Fuse! These lights are NOT on the TAIL fuse (or anything else with a sensible name) - they are...
-
NThanks to everyone for the advice. There was no sign of a vacuum leak so I replaced the MAF sensor (which was an after-market non-OEM...
-
Nnegusm replied to the thread P013B and preventative part cannonadeChat GPT is wrong. The code is for sensor 2 (downstream). AI makes up things.
-
Nnegusm replied to the thread P013B and preventative part cannonadeIf you replace it, only use OEM. You sure it's the upper one? Isn't this code referring to the downstream one that comes after the...
-
Nnegusm posted the thread Has anyone retrofitted a power hatch into a CX-5? in CX-5 Accessories & Utility.My mom has a CX-5 and the lift gate is just heavy enough that it is bothering her aging hands. The Mazda 5 she used to have was fine as...
-
Nnegusm replied to the thread Blower motor not workingBTW, you're also in the Mazda5 forum. The one for CX-5 might be more better for you.
-
Nnegusm replied to the thread Blower motor not workingA 2014 probably won't throw codes for this. Maybe an expensive reader will get something from the BCM. Usually these things will...
-
Nnegusm replied to the thread Blower motor not workingLook at the wiring and the voltages at various points of the circuit. Maybe look at the wiring diagram for your car and see what else...
-
Nnegusm replied to the thread Grey smoke, constant regenerations, rough idle and warning lightsIf you smell diesel when it's smoking, you're probably looking at a bad injector, bad compression or bad timing. Get a compression...
-
Nnegusm replied to the thread Intermittent P2187 engine code errorYou are running lean so you've most likely got a vacuum leak. Do the brake cleaner vacuum leak finder trick. This will find leaks you...
-
Nnegusm replied to the thread Mazda3 front strut stuck in knuckle even with spreader toolI used a Quarter and bolt trick it open a bit then a Big sledge with a block of wood to hit it out. I did this on a 2010 Mazda 5 and...
-
Nnegusm replied to the thread How to change A/C and Heater Knob lights?This is me. I pulled apart an entire dash to replace a single bulb. Then a week later I had to do it all again for the second bulb...
-
-
Loading…
-
Loading…
-
Loading…
Mazdas247 Stats
New Posts and Comments
-
-
Valvoline's "Restore & Protect" syn oil cleans engines- Latest: SparkYellow
-
