-
-
Mmadar reacted to Antoine's post in the thread Replacement HID headlight units for 2012 CX-5? with
Like.
First of all, spot on and now with readily available auto translation, quite possibly in any language! 😁 Secondly...PSA for... -
Mmadar reacted to ADS-B's post in the thread Replacement HID headlight units for 2012 CX-5? with Like.
You won't find anything better than this forum. Not in English, anyway.
-
Mmadar replied to the thread Electrical Issues?could very well be. Try disconnecting it.
-
Mmadar replied to the thread Electrical Issues?I'd start checking any and all grounds, look for corrosion, make sure those battery clamps aren't corroded on the inside and tight enough.
-
Mmadar replied to the thread Electrical Issues?I'd try a new battery, not recharging the old one, a new one
-
Mmadar replied to the thread Lifting angle and levels when changing fluidsAs far as the trans goes, best to refill with the same amount you took out, measure the fluid when it's cold. Then back off your plywood...
-
Mmadar replied to the thread Which of these three top oils?That Valvoline seems like amazing stuff.
-
Mmadar replied to the thread Which of these three top oils?Lots of in-depth conversations of synthetic oils on that forum enough to make your head spin.
-
Mmadar replied to the thread Which of these three top oils?Mobile 1 isn't a fully Group IV synthetic, hasn't been for quite a few years. They were 30% PAO a few years ago and since then that...
-
Mmadar replied to the thread Delphi Control ArmsI miss those greasable ball joints, at least when the seal starts cracking you know you can get some lubrication in there.
-
Mmadar replied to the thread Which of these three top oils?Amsoil, currently using
-
Mthat is a "one size fits all" filter... it's not specific to a skyactiv engine... it's application listed is also for the protege, 626...
-
MI haven't entirely dismissed lubrication issues, but I'm still doubting it.... but, what oil filters have you been using? Using any...
-
Mmadar replied to the thread Delphi Control ArmsDon't know, but I had mine done 2 years ago with Dormans (Aftermarket supplier). Drivers side ball joint was popping in and out already...
-
Mmadar replied to the thread Brakes Need Work AgainThat's an interesting suggestion. I tend to let my old rotors pile up and them bring them to the city's recycle center. I may have to...
-
-
Loading…
-
Loading…
-
Loading…
