CX-5 Photos - Share your shots with us!

[Chris_Top_Her]

That's a good point, I forgot they include billet brackets now (they didn't when I bought it and I bought Hochkiss).

 

[rwortman]

My new GT. Loving my new tall sports car.

 

[Chris_Top_Her]

Finnaly finished cutting my towers so that I can adjust camber from the top. Set it to max neg which is approximately 2. These are not stance coils so there not gonna go -4 or something. Amazing what 1.5 or so of camber did for turning lol. Gonna install my rear arms sometime this week and go in for an alignment as I haven't had one since installing the coilovers. Also fixed an issue where somehow one coil was set about 6 mm higher and the preload was allowing the spring too much play.

 

[tibimakai]

Nice Chris, but you should touch up the bare metals.

 

[Chris_Top_Her]

Yea I had been at that for hours today I'll be coating them with plastidip or something after I get all the debris off. There is still lots of oil from when I was cutting the metal.

 

[tibimakai]

Primer and paint.
Paddle shifters are installed and working great!

 

[Chris_Top_Her]

Went on a mazda group cruise today.

 

[tdman]

A side shot of my car.

you should use this shot for your avatar, show the car better with the drop and 20" wheels.

 

[tibimakai]

You are right.

Nice Chris. The lettering from the wheels is coming off?

 

[Chris_Top_Her]

I wiped it off. The paint i used was too old can the oil was seperating. I turned brownish shortly after applying it. Surpisingly, the walmart paint pen base held up very well. I gotntired of scrubbing with the scouring side of the sponge and left em.

 

[tibimakai]

I will try this myself, but I think I will use the 3M marker.

 

[Chris_Top_Her]

I will try this myself, but I think I will use the 3M marker.

Honestly I'd recommend the Walmart paint pen.. I got it in the arts and craft isle. That s*** didn't yellow, and it was very stubborn t remove even with a scrub pad.

 

[tibimakai]

Wheel tire fit. 245/45R20 ET36, wheel width is 9.25"

 

[Chris_Top_Her]

Lol that ghetto air duct. You should look at the OEM mudguards. They go very well with a drop and flush wheels (actually yours seem to slightly poke (pow)). It gives the rear a wide body look.

 

[motoXracer56]

Here's my fiance's cx5 and my 3.

Sent from my SM-G925T using Tapatalk

 

[tmz_99]

got the new shoes fitted today - will take decent shots next week

 

[boandlkramer]

ZeppelinPlatz Nuremberg

Sent from my iPhone using Tapatalk

 

[SystemDesigner]

Not quite as cool as many here but here’s my new to me ‘13 CX-5 GS AWD.

Les.

 

[2016MAZDACX5]

Mazda Nordic hello i thought the cx 5 can only pull 2000 lbs

 

[boandlkramer]

Schinderhannes gasthaus, Weiden, Bavaria, Germany

Sent from my iPhone using Tapatalk