MSP Rev Limiter??

[OrangePeel]

Ok i have only had my car for a short time (almost 4 weeks now) and im curious to where the stock rev limiter is? i know there is an easy way to find this out. go out and hold my foot to the floor but id rather not.. ive been searching and seraching but cant seem to find it on here.
Also on that note. what can the MSP safely rev to with stock internals?

thanks. thats all for now. loving my car.. but having terrible trouble with the mazda service I have been getting around my area.

 

[stdntDrvr]

not quite sure...but i haven't hit it...really no need due to the power band, imo.

 

[JOMO]

If I remember correctly its at 7200rpm. But, your better off shifting at 6800 cause the power drop off.

 

[MSP2024]

yeah its about 7200 i have bounced it a time or two

 

[Outlawstar98]

7200 IIRC, but why hit that??? just a stupid idea....

 

[dstmsp03]

seriously.. why go that high, i am full spool at 14 psi around 3200 rpm (my current setup) and know i could easily be around my 20 psi where i want with my build by around 3600.. power band drops after 6200-6300..

 

[JOMO]

seriously.. why go that high, i am full spool at 14 psi around 3200 rpm (my current setup) and know i could easily be around my 20 psi where i want with my build by around 3600.. power band drops after 6200-6300..

All the person did was ask the rev limit. Its good to know basic knowledge on your car. Didn't say they were going to redline it everytime they drive. And yes, the t25 runs out of steam were you stated, but if they plan to go big turbo, cams, however which way, then you can go all the way to redline if power is made.

 

[OrangePeel]

All the person did was ask the rev limit. Its good to know basic knowledge on your car. Didn't say they were going to redline it everytime they drive. And yes, the t25 runs out of steam were you stated, but if they plan to go big turbo, cams, however which way, then you can go all the way to redline if power is made.

thanks for backin me up lol. I was just wondering like you said. just wanted to know where it was at.
I dont drive my car hard at all. I had a subaru before this and im use to low end power. the highest i ever rev my mazda is to 6 at most, since thats what im use to. my subaru was out of steam at about 5500. im so not use to this little 2 liter turbo. im still use to my torque monster, big block 2.5L subaru boxer engine lol

but now that I know you "can" rev it that high maybe il take it a lil higher. where exactly does the boost start to roll off. I think i seen some stock dyno graphs and it starts to drop off at 6400?