Home Depot Lip
- Thread starter SHAGwagn
- Start date
lil_red_wagon
Member
- :
- lil white p5
jam_asian85
Member
- :
- Mazdaspeed 3
dawg if you do it, i'm going to come over and kick you! then rip it off
Yes.
lmaooooo.....why??
this is like the 10th thread about this! someone please do a search and add to one thread. There is one that has a lot of pics of cars with it done and then 3-4 others with a few pics in them.
I wont bother to search and post it in here, i'll have the OP make the search
I wont bother to search and post it in here, i'll have the OP make the search
this is like the 10th thread about this! someone please do a search and add to one thread. There is one that has a lot of pics of cars with it done and then 3-4 others with a few pics in them.
I wont bother to search and post it in here, i'll have the OP make the search
yeah? i tried. show me please. thanks.
jam_asian85
Member
- :
- Mazdaspeed 3
Pay me or you can help me with my portfolio for ARC
Looks bad on the speed 3 compared to the speed 6. Sure I can help you when u need to do it by?
jam_asian85
Member
- :
- Mazdaspeed 3
Yup, I believe the MS3 has a bulky look at the front end compared to the MS6 that's why
jam_asian85
Member
- :
- Mazdaspeed 3
Did it to mine too. I did it right after I bought it because its lower than my 6 and I pulled into a dunkin donuts and hit those parking stops with the bumper piece under the bumper. Extra protection plus some look FTW.
got anymore pics? how easy was the install? Just double side tape? Any help would great, im seriously thinkin about doing this next weekend. Also what size did u get the enkeis?
That actually doesnt look too bad....thinkin about it...
I just used 3m Outdoor double sided tape, need 2 packages of it. I didn't want to screw anything into the bumper especially if I wasn't going to like it. You basically just follow the line given to you by the bumper protector. Just put it in front of that. Also use Goo Gone or something similar to clean the bumper in that area before you start.
Tip - Lay out the sealer before you stick it on the car, put one side of the tape on the sealer. Leave the other side with the red piece still on it (don't peal it yet). Don't cut it to length yet. Stick a few inchs of it on the start of the bumper. Dont peal anymore of the red side off yet. Hold the sealer on the part of the bumper you want about 10inchs away. Then you can pull the wrapper off until that point. Do that all the way around the car and it goes quicker.
Tip #2 - In the front of the bumper where it dips up, dont use tip #1 in that area. Go slow and give that area enough of the sealer that it won't pull back down. So basically don't try to spread it too thin, you have plenty of the stuff. I learned this the hard way when I did it on my 6, I kind of skipped over the dip and tried to press it back into the dip but it just pealed itself off the bumper in that area. Sucks having to do it over.
Let me know if I didn't explain that very well. Or have any other questions.
