HiBoost Mazda3 at 16 psi

daedalus said:
holy ******* s***. Scion TC watch out. I'm guessing this HAS to be with forged internals, but still, thats ******* impressive. Hows the tranny holding up?

This was done on a completely stock motor. HiBoost, correct me if I'm wrong...
 
status50 said:
Do you have a graph where HP, TQ and airfuel is being shown?

My dyno does not have the A/F ratio linked into it, but it is between 11.7 to 12.1 under boost and around 13.7 while cruising.
 
HiBoost TS said:
My dyno does not have the A/F ratio linked into it, but it is between 11.7 to 12.1 under boost and around 13.7 while cruising.

What about TQ? Doesn't your dyno display TQ values as well?
I would like to see a Graph where TQ and HP are used..
 
just to clarify...

Juan- this is on a stock motor right?

A used MS3 sounds good in a few years lol
 
status50 said:
What about TQ? Doesn't your dyno display TQ values as well?
I would like to see a Graph where TQ and HP are used..

Here it is with the torque curve.

Mazda3%20at%2016%20psi%20of%20boost.jpg
 
This is with all stock motor, just the turbo kit and a 3 inch exhaust all the way from the downpipe. Of course the kit comes with a Haltech F10X and larger injectors. The run was made with 110 octane fuel as the motor starts to detonate at aroun 11 psi on 91 octane fuel.
 
Back