What have you done to your MS3 today?

[08cosmic3]

There was a guy at the other forum that went back to stock after he did the block vent mod but was denied warranty because Mazda said they found evidence he had modded.

 

[hugador]

Yesterday. Detailed interior, inspected my mods connections to make sure all clamps are tight, and did some dataloggin. Still great numbers. I did spike to 20psi this time. yikes

 

[liquidflem]

Not liking the car being stock after taking the Cobb SRI off the other day. Went out driving today and I get a lot of hesitation when going into WOT. I don't know what's going on =/. I remember accidentally dropping my MAF, but that was a month or so ago and it ran fine until i put the stock airbox back on. I disconnected the battery and it's been about 300 miles now since =/

 

[08cosmic3]

Not liking the car being stock after taking the Cobb SRI off the other day. Went out driving today and I get a lot of hesitation when going into WOT. I don't know what's going on =/. I remember accidentally dropping my MAF, but that was a month or so ago and it ran fine until i put the stock airbox back on. I disconnected the battery and it's been about 300 miles now since =/

Sounds like the stock BPV to me.

 

[LaraS]

Here are two shots of the trunk setup in the car. I'll have more pictures tomorrow now that all the interior pieces are back in.

 

[Nliiitend1]

Yay!

More marginally (if that) beneficial bracing!

 

[kneedragger241]

The rear end of this car needs to be less compliant?

 

[Saskatchewan17]

I'm sure she did it more for cosmetics than anything else.


Today I jumped off the forge bandwagon. Getting myself a Greddy type S.

 

[79535]

Installed the stock air box because I'm tired of fuel cut with the Cobb intake and CP-E TBE, especially in cold weather.

 

[LaraS]

I'm sure she did it more for cosmetics than anything else.

Not true.. .nice try though.

 

[navyagspeed3]

I installed new horn, AWR rear endlinks, and cobb sport springs. Loving that there is no more rattle from the factory endlinks!!!

 

[daonly1around]

Here are two shots of the trunk setup in the car. I'll have more pictures tomorrow now that all the interior pieces are back in.

[]http://larawdesigns.com/Mazdaspeed3/Photo%20Album/101009/1.jpg[/img]

[]http://larawdesigns.com/Mazdaspeed3/Photo%20Album/101009/2.jpg[/img]

i wanna see more pictures with interior back in the car!!

 

[mrdouble99]

Debadge mazdaspeed3

 

[LaraS]

Here is one. Not the greatest.. but the sun was going down. Better ones tomorrow or Tuesday.

 

[liquidflem]

Here is one. Not the greatest.. but the sun was going down. Better ones tomorrow or Tuesday.

That looks very nice. Had a chance to test it out at a track/autox?

 

[LaraS]

Not yet.. I just got it on last night and finally got an alignment today from my coilover install a few weeks back.

 

[Mr_Boom]

Installed Cobb Short-Throw shifter. Love the quicker shifting and better feel, should make for easier 2nd-3rd shifts during AutoX.

 

[liquidflem]

Installed Cobb Short-Throw shifter. Love the quicker shifting and better feel, should make for easier 2nd-3rd shifts during AutoX.

I'm very excited to see this as well. Once i get my short shifter plate installed. There has been times where I could have shifted to 3rd but didnt and instead road the redline a bit. We'll see how this shifter plate changes that. (band2)

 

[mr_mazda329]

In yo face CAI Owners! SRI FTW!

 

[Sport6]

Dealer replaced the struts and endlinks, though they said the sway bar bushings (I told them that was the problem when I went in) should probably be replaced and we can do that next saturday. They said the CEL wasn't on (went off the night before) and didn't show up (?) when they checked.

Of course when I drive it the next morning, CEL on P0401 on again.