Turbosmart BOV problem

[ms6DiGi]

I just installed my Turbosmart dual port bov a few days ago and everything has been fine. Today I was driving a little harder than normal and my check engine light went off.
The car is still running fine and everything sounds okay. Anything I should check off the bat tomorrow morning?

BTW
I have it running 50/50.

 

[chiefmg]

I just installed my Turbosmart dual port bov a few days ago and everything has been fine. Today I was driving a little harder than normal and my check engine light went off.
The car is still running fine and everything sounds okay. Anything I should check off the bat tomorrow morning?

BTW
I have it running 50/50.

First thing to do is pull the code and see what it is. Then you can figure out which direction to go from there.

 

[blackwidow]

I had some backfires with the 50/50 mode , so now i'm running the 100% recir mode without issue .

 

[Endless1]

yea i had the same problem i was running 50/50 and the car leaned out a bit so i altered it to run 100% recirc and its been fine ever since.

 

[desertmike680]

Samething. I was pulling CEL 301 in 50/50. Put it back to recirc and the code is gone. Couldnt be any happier.

 

[batou079]

Samething. I was pulling CEL 301 in 50/50. Put it back to recirc and the code is gone. Couldnt be any happier.

heh, thats why i went with the BPV instead of the hybrid.
full recirc ftw, i knew id end up going 100% recirc with the hybrid for those very same reasons. and paid way less to boot!