Keyless Entry

[Nem_MP5]

My keyless entry recently just ran out of battery... When i got the battery in the remote... My car have no reaction to the remote anymore... So I try to fix it using this thread http://www.msprotege.com/forum/showthread.php?t=116397&highlight=keyless
1. it didn't really work
2. The wording of the instruction is kinda hard to understand when it get to (Push driver-side door switch three times)...
Can anyone help me get my god damn remote to work.....

 

[ke20sprinter]

My keyless entry recently just ran out of battery... When i got the battery in the remote... My car have no reaction to the remote anymore... So I try to fix it using this thread http://www.msprotege.com/forum/showthread.php?t=116397&highlight=keyless
1. it didn't really work
2. The wording of the instruction is kinda hard to understand when it get to (Push driver-side door switch three times)...
Can anyone help me get my god damn remote to work.....

The button you press is the rubber boot, that covers the button for the door. Open the drivers door and look where you control the seat (to your left) and you'll see the rubber boot that controls the lights when you open the door.

WiL

 

[Nem_MP5]

thx man... Finally got the remote to work...

 

[ke20sprinter]

thx man... Finally got the remote to work...

Good, took me a while to figure out how to type out what I was talking about. That was alot of words just to say "the rubber boot button on your door sill."

WiL

 

[blownoffvalve]

i had a similar problem... thanks

 

[PlatinumMSP]

i did the orange wire trick with my turbo timer so that I could arm the alarm with the car running, but now I cant reprogram my new keyless controller! Any suggestions!!!!

 

[TheMAN]

you need to reconnect that wire so that the keyless entry module will know whether you turned the key to "ON" or not... disconnect it again after you programmed your remotes