Just dynoed my 03 MSP

[BIGCU]

hmmm are these numbers fine?
Only mod I have is a AEM CAI and boost gauge.

154.1whp & 136.5 ft/lb

(dunno) (dunno) (dunno)

 

[MetalSpeed]

That looks about average.

 

[505zoom]

Your torque seems a little low for the hp numbers, but the hp is about right for your setup. Not bad.

 

[MSP#735]

yea what he said, thats what i was thinking when i looked at the print-out....HP looks average...

 

[Stormtrooper77]

What's your stock boost reading?

 

[Spooled]

Something's wrong here. What's the deal with the AFRs? I've never seen anything like that on a stock MSP (CAI won't alter them that much). They are almost ideal under boost, and you should be making more power with those ratios unless there is something way off with the ignition timing.

 

[Spooled]

Actually, I guess your HP number are about right for that combo, but your torque has been moved up the powerband. Are you sure that CAI is the only mod?

Joe P. FPR by any chance?

 

[tekkie]

did you reset your ecu after you installed the intake?

its good to see someone with the same dynapack though cause I was a bit scared of my results, now I feel better

http://www.msprotege.com/forum/showthread.php?t=106085

 

[KySpeed]

Eh.. I made 134&134 same mods.. be happy

 

[BIGCU]

Yeah its the only mod i have on there.
ran at 3rd gear
1 fan
94 octane gas
the red was my first run when the engine was a little cold

stormtrooper - max psi was 7.1 i believe

spooled - no FPR

tekkie - yeah i did... I installed the CAI 3 days prior... resetted ECU... drove like a madman

I thought it I would have more torque but hmmm... I guess if its average then i'm happy with the numbers

 

[tekkie]

dont be dissapointed man, those numbers are not that bad, add a FMIC and an exhaust and thats where your going to see results, and of course a boost controller

 

[JHew84]

wow, i made 153whp and 153wtq with a completely stock MSP that is unflashed to my knowledge at least, previous owner claimed he had no warranty work done to it and that it had never even been to the dealer... and my AF's were terrible, started out at 11 and slowly creeped up to just below 13 at redline...

 

[jurgs01]

Different dynos will give different numbers. A good way to see your progress is to get it dynoed at the same place after you mod.

 

[JHew84]

ya, slight problem for me, its a 7hr drive, only reason i went was to hang out with a few different car clubs from different states ... i guess i'll just have to get another set of baseline runs from a local shop before i mod (which will be awhile haha)...

 

[BIGCU]

tekkie - not disappointed... i was happy about the gains of the AEM CAI, but this all comes to another reason to get a FMIC and exhaust... and of course the boost controller but then again... all this will make gf pissed
lol

 

[msp4you]

I think if you were to remove the boost gauge you would gain horsepower.






































haha j/k numbers look fine

 

[peepsalot]

why does the graph say flywheel torque and power, and not wheel?

 

[Lil Freek]

aren't dynapack dyno's extremely generous for numbers?

 

[JHew84]

aren't dynapack dyno's extremely generous for numbers?

i hope not, because he is making less power than me, and I dyno'd on a dynojet...