How-To Corksport testpipe

[954_ms3]

Anyone have instructions or link on how to install the testpipe, left the instructions about 300 miles away (bang).

 

[bova80]

haha it shouldn't be more than unbolting the 4 bolts and then removing stock and then putting in testpipe and bolting it back in.

 

[daonly1around]

you would "THINK" that, but its a little more involved than that, but its pretty self explanitory once you get under their

 

[954_ms3]

haha it shouldn't be more than unbolting the 4 bolts and then removing stock and then putting in testpipe and bolting it back in.

lawl i figured that much. i'll be more specific, springs, bolts, and washers?

 

[mazdaspeedster3]

Yea, replace the gaskets if there are any when installing test pipe...

 

[954_ms3]

alright going to go attempt the install now, if everything goes well expect a vid

 

[maestro]

remove that cross member below it for more simplicity, 4 bolts I think.

 

[954_ms3]

remove that cross member below it for more simplicity, 4 bolts I think.

wish i would have done this from the start but i didn't. anyways the install was easy, took maybe and hour or so. only problem is i can't get it to not leak. it mates to the stock downpipe perfectly, but the exhaust doughnut that's supposed to mate to the stock cat-back is poo-poo. oh well what can you do, i'll eventually get the exhaust depot downpipe since they're about 20 mins from my place. vid will be up in an hour or so

 

[954_ms3]

nice avatar btw maestro. i feel like half the people on the forums wouldn't know what movie thats from

 

[954_ms3]

vid didnt come out so great but here it is

http://www.youtube.com/watch?v=mSMZsWBSNWY&feature=channel_page

edit: whooops posted the wrong vid, please dont ban me (five-0)

 

[daonly1around]

just to let you know they will either take down that video or make you take it down...

 

[maestro]

nice avatar btw maestro. i feel like half the people on the forums wouldn't know what movie thats from

Heh, thanks, Clockwork is a classic, I get an oldies DVD for my B-day every year.

 

[funksilver07]

This is a very basic install. You could do it in about half an hour. Make sure your gaskets are good, and just unbolt the stock unit. The new test pipe should fit right into the same location and bolt right up...
Edit: Did you reuse the stock donut that was on the midpipe? I used a TXS gasket and the stock donut (it fits into the cutout flange on the new racepipe/midpipe, then that donut will fit into the CBE pipe to make a good seal...