hardrace engine mounts. rear, trans and passenger.

first off i do NOT have the front mount for sale. like to make that clear.

second. please PM me with any questions or to contact me. i dont get on the forums much anymore so i may not see any posts here. and please be patient i dont normally check pm's till the evening, but i will respond to everyone.

i have hardrace engine mounts for the rear, passenger side and transmission side of MSP's or protege sedans or wagons. these are advertised as being for manual transmission cars. not sure if they would fit autos as i dont know the difference between the mounts. i assume the tranny mount would be most different.

these are used. not sure exact mileage, but the previous owner had them installed for 2 years before switching cars and removing these. i bought them as a full set because i wanted the front mount to install in my car and he wouldnt part them. they are still in awesome shape, just a bit of surface rust. the rubber is near mint.

these are hardened rubber and are similar in design to stock mounts. they provide a huge performance improvement over stock mounts while not being super harsh with bad vibrations like some of the solid urethane mounts.

i am in canada and shipping go the states is unfortunately not cheap, so my prices reflect that. these INCLUDE shipping to the lower 48 states and are in $USD.


ALL SOLD!!!

EACH MOUNT: $50

ALL 3: $130.

i will only accept paypal and EMT.

on to pics.

all three

passenger.

rear.

transmission.

 

[thejackyltm]

if i knew for sure they'd fit an auto i may consider....anyone have any input?

 

[DarkAngel]

Transmission mount no to a certain degree due to brackets on point A and E that are welded on and minor differences, all others yes. Great set though. GLWS.

http://img.photobucket.com/albums/v496/20EVOLUTION01/TransMountDifference-1.jpg

http://img.photobucket.com/albums/v496/20EVOLUTION01/TRANSMOUNTDIFFERENCE2.png

http://img.photobucket.com/albums/v496/20EVOLUTION01/TransMountDifference.jpg

 

[thejackyltm]

but the actual engine mounts will fit then?

 

[DarkAngel]

but the actual engine mounts will fit then?

I wouldn't see why it wouldn't seeing that they look identical except for the two spots I advised about. I have read on here that "supposedly" the length from the bolt center to the end bracket was shorter or longer by the smallest amount from one another but I don't have each one to compare to verify though.

 

[00bluees]

pending sale on the trans and side . no interest in the rear as of yet.


i will say that i currently have a hardrace rear engine mount in my P5(obviously a different one than the one i am selling), along with a medieval front and AWR side inserts, the vibrations are noticeable but liveable. i just recently put the hardrace rear mount in the rear and they didn't increase THAT much over what was already there, and made a big difference in performance since my stock rear mount was pooched.

 

[gangstagangsta]

pm'd

 

[IshSonP5]

pending sale on the trans and side . no interest in the rear as of yet.


i will say that i currently have a hardrace rear engine mount in my P5(obviously a different one than the one i am selling), along with a medieval front and AWR side inserts, the vibrations are noticeable but liveable. i just recently put the hardrace rear mount in the rear and they didn't increase THAT much over what was already there, and made a big difference in performance since my stock rear mount was pooched.

if sale doesn't happen pm me. I could use the passenger and rear mounts.

 

[IshSonP5]

if sale doesn't happen pm me. I could use the passenger and rear mounts.

Bump, update?

 

[00bluees]

All sold!!!