CDT Components.. about to install the CL-61 but have a question:

[b_real45]

Ok.. I've been doing a little research and testing with WinISD Pro and I've decided that I'll be getting the e12k.44 but it wont be in a sealed enclosure. It'll be in a 2.0cuft box ported and tuned to 26Hz. This will allow a nice linear response and the -3db cutoff will be at 24Hz.. which is pretty low and I doubt I need to listen to anything lower.

 

[Astral]

Man, Rob, you read my mind!

I just spent a few hours experimenting in WinISD myself... posted some stuff in this thread.

Yeah, I agree, e12k in a ported 2cf/26hz is going to sound sawwweet! I just dont' want to compromise that much trunk space

I myself am planning on switching to 1cf/30Hz, if everything goes well. I just have to figure out where to get the box or how I'm going to make it.

 

[mazda5protege]

How good are those boxes that eD gives blueprints from on their website for each sub? I'm looking @ getting one of these subs also, and want to make their 1.5 ported 10" Sub box.

 

[servoeyes]

They designed 'em with a purpose. They're total sound geeks, so I doubt they'd give you bad advice. If you're not sure, ask them. They're really responsive, and awesome guys!

 

[b_real45]

Astral,

Great! I hope your ported box turns out great. I definitely think I'll be going with the 12k and have the box's width go from one end of the trunk to the other.. but it'll be slim so I will still be able to fit stuff back there. I'll take some measurements this weekend.. and if that is too much space, I'll just get a e10k.44 and do the same.. 1cf/30hz.