BC Sports Coilover - Set-up Question

[mspeedP5]

I am wondering what the safest depth would be for threading in the shock housing into the sleeve for the wheel spindle. The reason I ask is that I may have to raise (yes you read it right) the ride height to help with clearances for the 245/45-16 V710's.
They arrived from BC Sports with 118mm (4.25") threaded into the rear sleeve. To lower the car you would increase this amount. What would be a safe minimum amount? I don't plan on raising the ride height several inches but I'm just wondering what would be the safest minimum.

 

[mspeedP5]

On a side note, I prepped the coils yesterday with a coating of T-9 on the threaded sleeves. I don't want to run into any grief down the road with trying to adjust seized lock rings.

Still looking for some input on my original question tho'.

 

[Sleepy]

subbing for an answer too. Don't the instructions tell you?

 

[mspeedP5]

Well the instructions are poorly translated but after rereading them and putting two and two together I think that what they are saying is that there should be no less than 80 mm threaded into the sleeve...