AWR motor mounts, THERE ARE MORE THAN ONE KIND!

[ddogg777]

I have been emailing AWR back and forth today and they said that if we don't like the harshness of the urethane mounts that they have a softer bushing available that is still stiffer than stock. They are primarily used on auto trannies. Here is what he said:

The motor mounts are sold two ways. Standard trans and auto trans and come in a two piece set. front lower off the transmission and rear right off the starter motor area. They are both stiffer than stock but the auto trans ones are in between stock and standard trans stiff.

I already emailed back to find out price and whether or not they have a different composition. Who's interested?! I'm getting some for sure.

 

[ddogg777]

Here's an update:

The parts are identical physically between transmissions and mount in the same way. They are a softer durometer polyurethane bushings. Same price as the std. call Mitch and set up a group buy if you can. Thanks. parts are in stock.

Should we start up group buy number 2?

 

[Pmpkinhead]

I want some, I dont think I have a choice. If they're going to fix my car then I will get em!.
1244 (msporange

 

[johnjay5]

im interested!

 

[Equinox]

I might be interested in a softer rear mount, the rattle is pretty bad

 

[wscottl]

Depending on the timing, I'd be interested. Front and rear.

-Scott

 

[PaulMP3]

I might be interested in a softer rear mount, the rattle is pretty bad

werd

 

[p5sundevil]

get some Gb prices and so forth, and im interested. any help needed with running this im also down.

 

[ddogg777]

I pm'ed Mitch to see if he will do a group buy for the softer mounts. If he doesn't respond (too many emails to read) I'll get Tony at AWR to do it for us...

 

[PaulMP3]

can we just get the bushing and replace ours, if we already have the urethane one.

 

[thewrench]

Definitely interested in these!

JT

 

[1sty]

I am interested but one question:
Why the need for new ones?

 

[ddogg777]

I am interested but one question:
Why the need for new ones?

To get rid of wheel hop...

 

[1sty]

To get rid of wheel hop...

How about learning to take off better or get a maita ??

Basicly I never race and I don't want my car shacking like a bastard so I guess I am out. I just wanted to be sure it wasn't a reliability concern.

 

[Kooldino]

hmm. i'd want a mount that's BARELY harder material that stock but with no "holes", just solid.

 

[ddogg777]

How about learning to take off better or get a maita ??

Basicly I never race and I don't want my car shacking like a bastard so I guess I am out. I just wanted to be sure it wasn't a reliability concern.

I just hate the little shake when I let off the clutch. I try to rpm match and if I let off easy enough, it's fine, no bounce. But 80% of the time I'm off by 100-200rpms and when I let out the clutch, wobble..wobble..wobble.
I never wanted to get the AWR mounts because I heard that they were very harsh, so I wrote AWR to see if they could make it just a bit softer, that's when they said they did have some for auto trannies that can be used for stick.